AP can send send two ssid in this way?

[eigrpy]

Hello, Diagram is like this:  WLC-------SW------AP

Two SSIDs(abc10 and abc20) are created and associated with two interfaces(vlan10 and 20) respectively at WLC. The AP is connected to the SW at access mode with vlan 10. The SSID abc20 can be sent out via the AP? Thank you

[Leo Laohoo · Accepted solution]

AP Groups

[eigrpy]

Thank you!

[Scott Fella]

I believe you are asking that SSID 10 gets sent through the controller and SSID 20 is placed on the switch local to the ap? If so, then you need to research FlexConnect. FlexConnect can allow traffic to be tunneled back to the controller or locally switch on the switch the ap is connected to. The AP would need to be on a trunk port. All the information about FlexConnect is in the guides and blogs you can find almost anywhere.

[eigrpy]

Thanks for your reply. We have two vlans: one is for employee and other is contractor(or guest). If the AP is connected (access mode) to the switch, is it possible for the AP to send out two SSIDs for employee and contractor respectively?  I can see a lot people use trunk for the function, not sure if access mode can do it.