AP Commands

[tsmarcyes]

I was wondering if someone could give me a better explanation of what the below commands do. The AP help for the command doesn't really help me a lot. Besides the textbook definition, when would you use them and when not to, what they're used for, real-life scenarios, etc....

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

bridge-group 1 source-learning

bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

[wdrootz]

These commands are used for bridging purposes and are automatically enabled when you configure the Bridge-group command on the radio or the fast ethernet interface. These commands should not be disabled. Else the connectivity to the WLAN will not happen.