02-13-2020 02:37 AM - edited 07-05-2021 11:42 AM
Hi All,
I wanted to check how other do this in their networks.
We are setting up a new wireless network and need to authenticated the APs as they are connected to the network using EAP-FAST. The network has been configured in closed mode using ISE.
The EAP-FAST settings will be applied to the WLCs so the question is how do we allow the APs to reach the WLCs in the first place to be able to retrieve the EAP-FAST setting/credentials? Do we need to seed the APs first on an open port or is there a better way of doing this?
02-13-2020 02:46 AM
Check this post ..it may help :
https://www.ipstorming.com/cisco-ise-802-1x-ap-authentication/
Regards
Dont forget to rate helpful posts
02-13-2020 02:48 AM - edited 02-13-2020 02:51 AM
Removed my post :) just realized a good post shared by fellow mentor with good example :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide