Hello,I'm experimenting a strage issue with some AP1142 that prefer getting new IP from DHCP server rather than using the static ip already configured.I've got more than a hundred of 1142 APs already conected to a 5508, all with s...
Forum Posts
Resolved! Cisco 2500 Series Wireless Controllers
we have Cisco 2500 Series Wireless Controllers and Cisco AP (AIR-CAP1702I-D-K9) in our company and need to extend the WiFi range of device, don't want to change the device.please suggest any cost effective solution.
I have a WLC 3504 at a central location and six sites that use it, including the site containing the controller. The controller has an Internet breakout on port 2 and LAN access on port 1. I am looking at implementing Flexconnect and have been throug...
Hi! I'm at a complete loss here.My Meraki MR33 is working fine when I connected it Directly to our Modem-Router but now when I connected it to our firewall the Led indicator is steady orange. How to tackle?
I am trying to set up a very basic network on a WLC 3504. I want it to use web auth with a SSLcertificate signed by a 3rd party CA. The cable plugs in to port 2 on the WLC and goes out to the Internet using a dedicated port on the CPE on VLAN 11. Thi...
Facing this issue, few APs were not working so rebooted the WLC, after reboot no APs were showing, set the Controller to factory defaults, configured as per the cisco guide but no hopepresent situation:WLC 4404, APs:LAP1242AG-E-k9Acess Points are on ...
Hello guys,I have to upgrade a wireless controller today and I am a little bit confused about fus version.I have the output below from sysinfo command:Bootloader version............1.0.18Field recovery image version.........7.6.95.16Firmware version....
I have two 1815i at home, both ME capable and ME enabled.If I unplug the AP that is running as "slave" AP, then immediately all the clients move to the AP still plugged that is the master.But if I unplug the master, it seems to me that clients loose ...
We have an IPv4 and an IPv6 ACL on a few WLANs on a Cisco WLC 2504. Is the CPU on the WLC being used, or the CPU on the LWAPP? All LWAPPs are in local mode.
Hello, I am trying to setup a Cisco VWLC VM in Hyper-V, whenever I boot the VM I get the following: Version is: 8.5.140.0 Server OS is: 2016
Please let us know if we can use any alternate of power supply “AIR-PWR-B=” if yes the please share the PID of the same. AP : AIR-CAP1702I-D-K9
Resolved! New SSID no Signal Strength
Hey all,I have wifi network with 2HA 3500Series Air WLC and 14 1852 APs. I had 2 SSID one is 802.1x and one for certificate provisioning and everything is okay. Yesterday I had to create a new SSID with the same network as 802.1x but with MAB configu...
I registered 8832 wireless speaker phones to the call manager via a wired connection. I want to set them up to use wireless.I added the voice vlan to the trunks going to the WLC I configured the calkmanager wireless profile and created a new ssid fo...
Hi all,I have three controllers in Mobility mode. the Mobility Anchor is spontaneously flapping and I have tried to remove the mobility features and readd the peers. It was fine for a short time. Then after a few hours, it started flapping again. So,...
I would like to create an additional nco group called ncseng just like ncsoper and assign users to this group based on an LDAP role. What I have created so far is the following for web access and cli access:set nacm groups group ncsengset nacm rule-...
