07-08-2013 05:48 AM - edited 07-04-2021 12:22 AM
Hi,
I would like to reduce the output signal from a group of APs connected to a 2504 controller. Is there a way to do this from the controller, or would I used the local power command on each AP to accomplish this or is there another way to get this done?
Thanks.
Solved! Go to Solution.
07-08-2013 07:04 AM
You can do that from WLC GUI:
Wireless -> Access Point -> Radios -> 802.11a/n (or b/g/n).
Hold the mouse over the blue square on the right of the AP and from the sub-menu that appears press (configure).
From there you can change the power and/or the channel.
Rating useful replies is more useful than saying "Thank you"
07-08-2013 07:04 AM
You can do that from WLC GUI:
Wireless -> Access Point -> Radios -> 802.11a/n (or b/g/n).
Hold the mouse over the blue square on the right of the AP and from the sub-menu that appears press (configure).
From there you can change the power and/or the channel.
Rating useful replies is more useful than saying "Thank you"
07-12-2013 05:46 PM
Hello ,
As per your query I can suggest you the following solution –
You need to go as Wireless -> Access Point -> Radios -> 802.11a/n (or b/g/n).Then you can use the local power command on each AP to accomplish this.
Hope this will help you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide