Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Hi all,We have Cisco 5500 serires wireless controller with Software Version 7.0.220.0. Now the requirement is i have to create a new SSID/WLAN which should belong to dedicated VLAN too.Kindly let me how to acheive this requirement???w...
I swapped out a 7945 with a 7965. I set the proper attendant console user and password, and selected the MAC address for the new phone but I still get an error message as followsYour administrator must associate the phone with a valid application u...
Hello all,we are facing some issues during testing autonomous 1602 for future deployment. We are using AIR-SAP1602E-E-K9 with IOS version 15.2.(2) JB.After activating both 2,4GHz and 5GHz radios the Status Tab of both shows Transmission Power - Error...
Is it possible to setup a Cisco 8510 with multiple RRM groups, we are taking over a new building where the 1252 series AP's are on a DAS system, and need to have DCA, and TPC disabled.
HI,Is posible that two mesh AP (rap and map) can communicate in different BGN? My code is 7.3.112.0, in a indoor mesh.Thanks,Marco Muñoz
I have two radius servers configured in cisco wlc 2504, few users are unable to authenticate and connect to WLAN. For some uses Im getting these logs71 Mon Aug 5 12:54:58 2013 RADIUS server 172.16.100.254:1812 failed to respond to request (ID 208) fo...
Hello,If I were to deploy a network that were to use time difference of arrival (TDOA) for location based serivces, how do I syncronise my APs?I understand TDOA works by measuring the relative arrival time at each AP. Accurate timing information is r...
Hi friends!Does anybody heard about an issue with WGB (with Cisco 819 or Cisco 1262) regarding to the multicast traffic, wich just can go through the Native Vlan in a mesh network (with AP 1552)? Under this scenario, the wireless network should be fl...
Hi...I am struggling with weak signal coverage inside rooms where APs are hung on the outer walls of the rooms i.e. on the hallway, one the sides, not on the cieling. Laptops work fine but mobile devices (iphones, androids, ipads) suffer the most. Th...
We are creating a BYOD network, have any of you tried this?1) First time user attempts to connect to byod_ssid they are presented with captive portal page that requests AD credentials. In the back ground users MAC address needs to be captured.2) All...
how do you get the password for your cisco box or the internet box so you can use your personal phone to use the net and card square or stuff like that?
I have 5508 with 2 WLANS (corp, guest) I would like to be able to block certain users via MAC address from CORP but not guest. Can this be done. CORP is using WPA2+AESGUEST is using Web Auth ( guest is not setup as a "guest vlan" i...
According to the N+1 deployment guide, when the primary controller comes back up/online, the APs on the secundary (HA SKU) controllers should fallback to the primary. During my tests, this did not work. I enabled "AP Fallback" on both primary and sec...
Dear all,I have problem with flexconnect 7500 and 1140AP that can not be utilized ample channel list.only flex7500 DCA Channel List are 149, 153, 157, 161.would you let me know how can I use 36,44,52,60 ... so many channels available in KR country co...
What is the difference between ISE ( Idendity Service Engine ) & MSE (Mobility Service Engine ) & Prime Infra .How this will be used along with WLC & AP & wireless Users.
