07-08-2019 08:16 PM - edited 07-05-2021 10:40 AM
Hi Guys,
show ap dot11 5ghz summary -- cmd is not working in CLI, any idea why ?
And also can someone plz share some links where I can get some info on cli commands.
Solved! Go to Solution.
07-09-2019 05:43 AM - edited 07-09-2019 05:47 AM
it is not an AP CLI command but a controller CLI command.
More specific for converged access networks.
Converged access design uses switches with builtin controllers (models mentioned by Sandeep)
Depending on the ios software in the AP you can search for the other CLI commands.
lke this: Cisco IOS Configuration Guide for Autonomous Aironet Access Points Cisco IOS Release 15.2(4)JB3a
this link Configuring Radio Resource Management includes the command you query and contains some info about other CLI commands on 3850 switches for converged access
07-08-2019 08:22 PM
07-08-2019 10:28 PM
I think it will work only if you have IOS-XE(3650/3850) devices who are managing LAPs.
Regards
Dont forget to rate helpful posts
07-09-2019 05:43 AM - edited 07-09-2019 05:47 AM
it is not an AP CLI command but a controller CLI command.
More specific for converged access networks.
Converged access design uses switches with builtin controllers (models mentioned by Sandeep)
Depending on the ios software in the AP you can search for the other CLI commands.
lke this: Cisco IOS Configuration Guide for Autonomous Aironet Access Points Cisco IOS Release 15.2(4)JB3a
this link Configuring Radio Resource Management includes the command you query and contains some info about other CLI commands on 3850 switches for converged access
07-09-2019 02:25 PM
Thanks pieterh
07-09-2019 02:25 PM
Thanks Sandeep.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: