12-12-2014 09:19 AM - edited 07-05-2021 02:07 AM
Hi,
Is Clean-air express supported on the 3650 wireless controller with 1602e APs? The Clean-air options on the controller are available but do not seem to be active. In the controller gui the Clean-air admin status is disabled and the Clean-air operation status is down. I did confirm the Clean Air option is enabled on the config menu for the b/g/n band. Am I missing something here or are these AP's just not supported? Thanks!
Solved! Go to Solution.
12-12-2014 12:23 PM
The 1600's and 1700's do it on hardware on the AP. It's not the full CleanAir you get from the higher end access points, but does do limited CleanAir functionality.
-Scott
12-12-2014 09:57 AM
CleanAir Express is different than CleanAir. Express means that the AP does the function of detection, not the controller. 1600's & 1700's run CleanAir Express and you don't have the 100% functionality of CleanAir with these access points.
-Scott
12-12-2014 11:11 AM
Scott,
if the 1600's are used as lightweight AP's do they essentially lose their ability to use cleanair because the controller has no settings for the express?
12-12-2014 12:23 PM
The 1600's and 1700's do it on hardware on the AP. It's not the full CleanAir you get from the higher end access points, but does do limited CleanAir functionality.
-Scott
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide