ap1130 reboot every 5 minute.

[yong1794]

The ap1130 is rebooting every 5min. This is working on WDS infrastructure and EAP authentication. There is no error log message and no radio interference and low CPU utilization. We have upgrade 12.3(8)JA, but auto rebooting problem is not solved. Is this unit need RMA?

[b.kokken]

Could it be the power settings?

Ensure that in the AP is aware of the power source if using inline power

Bas

[sbhadrav@cisco.com]

To display the primary and backup software build numbers with an indication of which is active, use the show
boot command.
show boot
Each Cisco wireless LAN controller retains one primary and one backup operating system software load in
nonvolatile RAM to allow controllers to boot off the primary load (default) or revert to the backup load when
desired.
Examples The following is a sample output of the show boot command:
(Cisco Controller) > show boot
Primary Boot Image............................... 3.2.13.0 (active)
Backup Boot Image................................ 3.2.15.0