cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
620
Views
5
Helpful
1
Replies

AP1130AG default mode

samirss
Level 1
Level 1

What is the default mode for AP1131AG,Autonomous or Lightweight Mode.

I am using WLAN controller 4402.

Thanks

1 Reply 1

Rob Huffman
Hall of Fame
Hall of Fame

Hi Samir,

It depends on the part #. The Cisco Aironet 1130AG Series may be ordered with Cisco IOS Software to operate as an autonomous AP or with Lightweight Access Point Protocol (LWAPP). Check out the part numbers (Note LAP1131AG for lightweight).

AIR-AP1131AG-x-K9 Cisco IOS Software 802.11a/g Non-modular IOS AP; Integrated Antennas

AIR-LAP1131AG-x-K9 LWAPP 802.11a/g Non-modular LWAPP AP: Integrated Antennas

From this doc;

http://www.cisco.com/en/US/products/ps6087/products_data_sheet0900aecd801b901c.html

If you ended up with the Autonomous AP, it can be converted to LWAPP using the LWAPP conversion tool.

Hope this helps!

Rob

Please remember to rate helpful posts.....

Review Cisco Networking for a $25 gift card