I'm using a WLC 5508 and light weight 1142 AP's with software version 7.0.116
I wonder why there is no cli-clear or cli-reload command if I am connected via SSH/telnet to an access point. When I connect through console port there are this commands available. Is this a configuration issue?
Any ideas? Thanks in advance.
I was able to ssh to my 1142 and do a clear and reload command. Did you make sure you are in enable mode? I'm running 126.96.36.199, but I don't think that matters.
shame on me
I've worked with the default login and password. After changing it in global config dialog at my WLC, I can see much more commands at the cli prompt.