AP1142 cli clear command missing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-29-2011 01:18 PM - edited 07-03-2021 09:18 PM
Hello all,
I'm using a WLC 5508 and light weight 1142 AP's with software version 7.0.116
I wonder why there is no cli-clear or cli-reload command if I am connected via SSH/telnet to an access point. When I connect through console port there are this commands available. Is this a configuration issue?
Any ideas? Thanks in advance.
Regards,
Robert
- Labels:
-
Other Wireless Topics
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-29-2011 07:12 PM
I was able to ssh to my 1142 and do a clear and reload command. Did you make sure you are in enable mode? I'm running 7.0.220.0, but I don't think that matters.
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-31-2011 12:15 AM
Hello,
Yes, i've been in enable mode. i will try the new software image.
Regards,
Sent from Cisco Technical Support iPad App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-31-2011 07:58 AM
Keep us posted if that does indeed fix it.
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2012 07:51 AM
shame on me
I've worked with the default login and password. After changing it in global config dialog at my WLC, I can see much more commands at the cli prompt.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2012 07:53 AM
At least you got it working.
Sent from Cisco Technical Support iPhone App
*** Please rate helpful posts ***
