cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
578
Views
0
Helpful
2
Replies

AP1200 keeps rebooting after IOS upgrade

garethleek
Level 1
Level 1

I have an AP1200 that I have just tried to upgrade to IOS. After the upgrade the AP keeps rebooting itself. I have connected through the console port and the AP boots, loads the file flash:/c1200-k9w7-mx.122-11.JA3/c1200-k9w7-mx.122-11.JA3 (lots of #'s) and then it reboots and goes through it all again.

I have tried the procedure to recover from a bad upgrade, but when I try to tar -xtract the upfrage file from tftp it says that I can't write to flash!

Please help.

2 Replies 2

kmarrero
Level 4
Level 4

If you have the G radio card installed, remove it and upgrade the access point to 12.2(13)JA or later and then install the radio card.

Thanks for that. I found an alternative solution.

I formatted the flash memory, and then used "tar -xtract tftp:/// flash:" and it is now working.

Review Cisco Networking for a $25 gift card