AP1832 ME Image not able to save static IP

[ajayvsalvi]

Hi,

I need some help configuring the AP1832, everytime I give a static IP to it via console or ME GUI, it does not save it, and takes IP from the DHCP, even if I stop the DHCP server and give it a static IP, it goes into APIPA ip and does not respond until I start the DHCP again.

Any help is appreciated.

Thank you

Ajay

[Sandeep Choudhary]

Hi Ajay,

just wait for the AP to join the controller and change the IP address using the GUI.

Regards

Dont forget to rate helpful posts

[ajayvsalvi]

Hi Sandeep,

Thank you for your input, I have tried this method, but it still doesn't work, it is a Mobility Express virtual controller. Everytime I give the APs a static IP, it just skips it and takes IP from the DHCP, if available.

Looking forward to your response.

Ajay

[Sandeep Choudhary · Accepted solution]

As i said earlier...let it take DHCP IP address..and do the rest of the configuration.

Once it up and running ..then just change IP.

Regards

Dont forget to rate helpful posts