Hi NG,
i'm currently trying to configure a AP801AGN-E-K9 sitting within a 892W router.
it was working previously with the following config, i just don't find it!!!
service-module wlan-ap 0 bootimage unified
interface Loopback0
ip vrf forwarding XXX
ip address XX.XX.XX.XX 255.255.255.255
!
interface wlan-ap0
description Service module interface to manage the embedded AP
ip vrf forwarding XXX
ip unnumbered Loopback0
arp timeout 0
!
interface Wlan-GigabitEthernet0
description Internal switch interface connecting to the embedded AP
switchport mode trunk
ip vrf forwarding XXX
Logging into AP and its outputs:
telnet Lo0's-IP-ADDR 2002 /vrf XXX
OUTPUT:
AP6400.f1ce.b5ba#sh ip int brie
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0 unassigned YES DHCP up up
*Apr 18 19:52:56.959: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!
*Apr 18 19:53:06.959: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!
*Apr 18 19:53:16.959: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!
could someone please guide me to a AP801AGN-E-K9 configuration manual in combination of 800 series routers..
Thank you
regards,
colin
