APs radio scan / WLSE 2.5

Mark3000 · ‎04-01-2004

Hello,

1/ I am trying to run some APs radio scan on the WLSE 2.5/AP1200(12.2(11)JA1) but no way.. Once I launch the job, I have a failure with a log:

-----------------------------------------------------

INFO: Executing the AP Radio Scan

INFO: Max Tx Power 100mW

INFO: Number of devices selected to participate in AP Scanning: 3

WARNING: Skipping device AP1200_03 because it is not registered with any WDS

WARNING: Skipping device AP1200_01 because it does not run required software

WARNING: Skipping device AP1200_02 because it does not run required software

ERROR: Aborting execution of AP Scanning task because there are no applicable Radio Interfaces that can participate.

-----------------------------------------------------

Any help, will be great.

rmushtaq · ‎04-01-2004

For all Radio Management feature in WLSE 2.5 to work, the following must be setup/met before you can use it:

a) The AP must be running IOS 12.2(13)JA or later. The version that you're running will not work.

b) WDS must be setup first properly, WDS AP must be authenticated with WLSE and all APs must be managed by the WLSE as well.

c) Currently, Radio Management features only support 'b' radios. a/g support is coming in the next release.

Mark3000 · ‎04-02-2004

Hi again,

WLSE 2.5 offers a number of toolkits and features for radio management including :

- Radio Manager

- AP Radio Scan

- Client Walkabout

- Location Manager

- RM Assisted Configuration

- Manage RM Measurements

On the Help/Documentation of WLSE, I can not see what are the requirements of each feature (AP IOS ?, WDS or not ? etc).

Can some one give any help for this issue : URL s? Links ? or direct answer ?

Thanks in advance.

--------------------------------------------------------------------------------------------

- Here an example of a a radio scan I have lanched :