Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
I have two Cisco 1310 devices that I configured for Point-to-Point conection. One is configured as a route-bridge and the other as a non-root-bridge. I calibrated the radio signal using the "led calibration method" in install mode. The ap's are confi...
All Cisco docs talk about "trunking Vlans between switches when using the WLC. My customer is running Layer 3 and doesn't want to do trunking. Will the WLC still communicate with the AP's is we did say "tunneling" between the switches? In other words...
Hello.I am engaged in a WLAN project that use a Cisco ACS integrated with NT Domain for authentication and the Access Points used are Cisco 1200 series. All was going well until a user to start to share the WLAN as a repeater using a Windows XP and w...
Can the lightweight access points be controlled by WLSE or do you need to have a WLAN Controller?
A cisco 1010 that runs multiple Wlans which are connected to diffrent dynamic interfaces (with version 4.x aireos). Must that AP be connected as a trunk to the switch? And if yes does it then mean that for each wlan there is a different tunnel to the...
Is BR1400 Model a WI-FI Alliance?I have serched WI-FI certified products list on WI-FI web site,But i can't find BR1400 in the list.
in aironet i`m unable to set a fixed channel in the 5 Ghz (because of eu dfs). However in airespace i can se the channel to manual override in 5 Ghz. What will happen when a radar turns up in the same channel,does the radio turn of as it is required ...
Hi guys,I have 10 Cisco 1000 series APs and 2 controllers in the same VLAN. How can I register 6 APs associate to controller 1, but the other 4 APs associate to the controller 2?Thanks,yytellmey
Anyone can perform the following (WPA with MAC authentication) on the latest IOS code ??
Dear SupportI have a Guest WLAN that uses web authentication via a 4404 WLAN controller and ACS box. It works but every 20 minutes the session times out and they have to re-authenticate again to get wireless access.We have other WLANs for phones and ...
Hi, I am setting up a WLC2006 with 2 AP1010's. I cannot get the controller to see either AP. When I place the AP's on a network with a WLC 4400, they are recogized immediately by the 4400 at Layer-2 LWAPP. Since the WLC2006 only works at Layer-3 LWAP...
Someone knows where could I find the certificates for the homologation in wireless?Thank you
Hi All,The previous problem of which I started another conversation here:http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddba023 somehow dissape...
How do I get the ACS server to work with Novell to querry for users/passwords? I was told by a cisco engineer that ACS would be able to querry our NDS tree for accounts. I see the radius and ldap but cannot figure out how to exactly get it to work.(L...
Hello everybody....Is it posible to make a Bridge 802.11 a with Aironet 1232G and AP 802.11 b/g simultaneously? are there antennas with connectors TNC for bridge 802.11 a?in the case of use antenna yagi AIR-ANT2410Y-R that it has only one connector s...
