Association Table for IOS access point

[asmithasmith]

I've recently converted all of my 350 access points from VxWorks to IOS. With the VxWorks it was possible for me to look at the association table and see all client associations to all access points on the network. Is this possible with the IOS software?

[jolmo]

Mine is IOS 1200 AP. Not sure if using same commands as 350, but in 1200 I use "show dot11 associations".

Hope this helps

[twscrb561]

Thanks. But I was hoping to be able to do it like I could with VxWorks - - from the web interface.

[tcggg0]

You can only see client associations to that particular IOS access point via HTTP, you cannot see all AP associations via the map tab like before. You can click the network map tab, enable it and see all ap's and SOME clients on the network via IOS. Make sure you disable this tab after you view it.