Wireless

I am converting a wireless network that was using EAP-TTLS to WPA. It works well from my laptop, which is using XP SP1, with onboard wireless nic. This works fine. My customer is using Cisco 350 PCMCIA cards and is running XP SP2. I have the PC set f...

I have a 1200 ap that is setup with 2 vlans. Vlan 200 and vlan 300. The client is able to successfully connect to vlan 200 and get a dhcp address with no issues.When the client tries to connect to vlan 300, he associates with the AP but cannot get an...

Hi,I have just setup an 877W with a very simple wireless config using a BVI to bridge between the radio interface and vlan 1.The problem I am having is that I have a wireless HP printer - the wired LAN clients can print to the wireless printer with n...

HiWe have a rather large deployment of 1100 and 1200 APs and their configuration has not changed today except for a wlse config job to deploy a new ssid (I've browsed it rapidly and there seem to be nothing wrong there). Some but not all my APs winde...

On an AP, filters can be applied to inbound or outbound traffic on interfaces (fastethernet, radio80211b or radio80211a). When I have configured vlans and then whe have subinterfaces, Can the filters be applied to subinterfaces? and then different fi...

i have implemented Wireless bridges between buildings , but i do not want that wireless clients can connect to the bridges configured as :role = rootas they are used only for infrastructure. I cant find infos on doc.can you help???

Does leap work with freeradius??

This is mostly a design question...I need to implement an open wireless access point for visitors who comes to our office for a few days or a few hours. i.e something simple to use for these people who are generally executives or clients and who do n...

Are there any significant differences that the 1400 will do that a 1300 won't?

I recently upgraded a select group of my access points to 12.3(7)JA. After the upgrade I began receiving "AP Memory Utilization is Degraded (80%)" alarms in WLSE on the upgraded APs. If I downgrade to 12.3(4)JA the problem goes away.I think the issue...

HiI've problem with transmition dhcp request from mobile clients to DHCP server.AirOnet obtain ip address from DHCP, but clients can't obtain the addresses.I configured AirOnet in agreement with instruction but steel is problem.Configuration:version ...

I have two AP-1232AG. The "a" radios configured in "bridge" mode (root-bridge and non-root-bridge). I would like to manage non-root-bridge from root-bridge LAN port. It is possible ? The non-root-bridge IP address doesnt answer me (www browser). In t...

Hello,I know this isn't Cisco specific, although I have a Cisco 1200 wireless network. While doing a security scan with NetStumbler I saw a lot of Peer to Peer (computer to computer) networks. I have a Sniffer but can not find where these computers a...

A new project require us to set up 2 AP 1200 in a room, and to configure one of the AP in standby mode. I've followed closely to the CCO documents on hot standby setup but couldn't get the standby AP to associate to the Active AP.It always give the s...

HiHas anyone configured QoS with the new AireSpace devices? I have a 4100 series controller with lots of APs, however it doesn't appear to mark QoS on the wired side of the network..I've tried enabling dot1p in the wireless config pages, however it d...