- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2009 03:40 PM - edited 07-03-2021 05:10 PM
I am currently upgraded my 871W to AdvanceIPServices 12.4(22)T IOS which was done to fix a bug with not broadcasting my SSID.
Since then I have been having authentication issues. I am using WPA with PSK. My PC and the rest of the network devices can connect to the wireless router initially, but if the connection is terminated for whatever reason and I attempt to reconnect a device I receive an authentication error.
Attached is my current configuration. Any help would be appreciated
Solved! Go to Solution.
- Labels:
-
Wireless Security
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2009 04:08 PM
Couple of questions, are you using the 87x as a bridge? do you have reallllllly old devices in your network? If not:
dot11 ssid cisco
vlan 1 <---not needed
authentication open
authentication shared <---not needed
authentication key-management wpa
guest-mode
infrastructure-ssid <---not needed
From the config, you don't need to have the VLAN statement in the SSID, and you don't need the sub-interface under the radio. Just put the main interface in bridge-group 1.
HTH,
Steve
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2009 04:08 PM
Couple of questions, are you using the 87x as a bridge? do you have reallllllly old devices in your network? If not:
dot11 ssid cisco
vlan 1 <---not needed
authentication open
authentication shared <---not needed
authentication key-management wpa
guest-mode
infrastructure-ssid <---not needed
From the config, you don't need to have the VLAN statement in the SSID, and you don't need the sub-interface under the radio. Just put the main interface in bridge-group 1.
HTH,
Steve
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2009 03:42 PM
Steve not sure why, but when i took the authentication shared command out it started working properly.
