Autonomous Configuration by using Cisco Mobility Express

[oshaka321]

Hi Guys

I've got an cisco 1852 AP. Its model is AIR-AP1852ISK9C-RF. The Cisco Mobility Express software has already installed on that AP. I will use this AP for a wireless site survey. In order to do that, I should configure it as a standalone AP. If it is highly appreciated if you can explain me how to configure standalone settings for this AP by using Mobility Express. Many thanks.

Cheers

Oshaka

[Rasika Nayanajith · Accepted solution]

I would go with 8.5.120.0 , if it comes with earlier releases.

Follow below URL for how to configure it for sitesurvey

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-5/b_cisco_mobility_express_8_5/b_cisco_mobility_express_8_5_chapter_0100.html

HTH

Rasika

*** Pls rate all useful responses ***

[oshaka321]

Thank you very much for your support.

[Rasika Nayanajith]

Not a problem.

If you able to configure it using provided link, you can mark it as accepted solution.

Otherwise pls let us know any queries.

HTH

Rasika