09-20-2022 08:38 AM
I used to have a WLC controller. Recently, I bought a new C9115AX to replace the old WLC.
The new C9115AX is connected to another brand of Client device. I want to access my pc connected to the client through C9115AX. But cannot succeed. The connected client table only shows the client IP but no pc IP.
I enabled the passive client function and it works on my old WLC controller but not the new C9115AX. Is there anything I need to config on my new C9115AX?
09-20-2022 10:35 AM
- If you are using EWC , check verify the configuration with the CLI command : show tech wireless , have the output analyzed by https://cway.cisco.com/
M.
09-21-2022 07:32 AM - edited 09-21-2022 09:29 AM
I think the notes in this bug https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvy21664 will answer your question - not supported.
There's also a hidden bug https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvr24428 which you can see in bug search results:
09-21-2022 09:13 AM
It is for 9800 WLC model, not C9115AX EWC.
Are they the same?
09-21-2022 09:36 AM
- Note that EWC only supports access points in flexconnect mode , in that case https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvy21664 , would even be more applicable.
M.
09-21-2022 09:25 AM
Yes they are one and the same:
https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/nb-o6-embded-wrls-cont-ds-cte-en.html
"With the 9800 Series wireless controller embedded on the Cisco Catalyst 9100 Access Points" - as far as Cisco is concerned EWC is a 9800 series WLC running on the AP.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide