CAC Tool - Aironet 350

[Mr. Bash]

I am using the CAC tool to upgrade an Cisco aironet 350 AP which is currently on vxworks version 12.00

I am attempting to send it the helper image called "AP350-Cisco-IOS-Upgrade-Image-v2.img". The process starts but eventually fails and gives me the following:

Unable to Free the Mem via MultipleObject value setting (May 24, 2005 14:42:20)

Unable to Free the Mem via MultipleObject value setting (May 24, 2005 14:49:33)

Status:: Error: Unable to upgrade target access point due to possible free memory shortage.

Troubleshoot:: Increase the amount of available contiguious free memory in the target access point and retry the conversion process again

Any ideas?

[wong34539]

You get such error messages when there is not enough memory on the Accesspoint for the upgrade. Increase the amount of available contiguious free memory in the target access point and retry the conversion process again. You could also try removing the radio of the AP because that will also free up some memory on the access point.

[Mr. Bash]

Tried that but it didn't make any difference. Any other ideas?