Cannot Access GUI on AIR-CAP2602I-A-K9 Access Point

[agray000111111]

No matter what I try I cannot get into the configuration mode which is where I believe I need to be to enable the web GUI. When I put in its DCHP assigned IP address I cannot access the GUI. Obviouly I can Putty into it on the Console port. Thought?

HS-AP252-B102A#conf ?
% Unrecognized command
HS-AP252-B102A#configure ?
% Unrecognized command
HS-AP252-B102A#config ?
% Unrecognized command

Alex

[Philip D'Ath]

The is a controller based access point.  It has no GUI on the access point.  You use the controller to configure it.

[mohanak]

Refer the link : https://supportforums.cisco.com/discussion/11905426/failing-access-web-interface-2602i-ap

[agray000111111]

Okay, makes sense now. LOL

Okay so then I have 4 of these APs that we have attached to our network and the ports on the switch are configured the same way the ports that have other working APs. Those 4 are not connecting to the WLC. So that was the reason I was trying to get into the GUI of a working AP to see if the configs were different.

[Philip D'Ath]

Check the log on the access point log.  It should be a big hint.