cannot find cli command

[albertbank]

Dear Community

In the process of Wlc consolidation i have the task to move several hundred access points from about 15 controllers running 7.0.220 to a central HA pair running 7.6.130.

The test worked successful; i set the name and ip address of the primary controller in the ha tab of the ap to the new values and rebooted the ap.

Now i look for the corresponding cli commands.

Clueless I post this question here

Grateful for any hint

Albert

[Rasika Nayanajith]

Hi Albert,

Hope you looking for below CLI commands to run via your WLC CLI.

config ap primary-base <controller_name> <Cisco_AP_name> [controller_IP_Addres]
config ap secondary-base <controller_name> <Cisco_AP_name> [controller_IP_Addre]
config ap tertiary-base <controller_name> <Cisco_AP_name> [controller_IP_Addres]

http://mrncciew.com/2013/04/07/ap-failover/

HTH

Rasika

**** Pls rate all useful responses ****

[albertbank]

Thanks Rasika

That command you gave me allows me to overwrite the primary controller entry.

Now that primary controller in fact is a HA solution, so I need to delete the second entry. How can that be accomplished ?

edit: found it here https://supportforums.cisco.com/discussion/12245476/how-remove-primary-basesecondary-base-aps-en-masse#comment-10417236

Cheers

Albert

[Rasika Nayanajith · Accepted solution]

HI Albert,

Glad you found the way to do it.

config ap secondary-base ' ' <AP_Name> 0.0.0.0

You can mark the thread as "answered" if you get what you looking for

HTH

Rasika

**** Pls rate all useful responses ****