04-19-2017 09:43 PM - edited 07-05-2021 06:54 AM
I cannot reset to Factory Default Cisco 2504 WirelessController or Save Configuration. I telnet to device and use "reset system" command or hold reset button but it doesn't work.
I can't connect to device via Console Port
Any one Help me!!!
04-19-2017 09:48 PM
The way you reset a controller is to console into the device and boot up the controller and then hit esc to breakout of the boot. There is an option to factory reset there.
-Scott
*** Please rate helpful posts ***
04-19-2017 09:50 PM
Option 5 when you break out. See this link:
https://supportforums.cisco.com/document/8941/how-reset-wireless-lan-controller-wlc-factory-defaults
-Scott
*** Please rate helpful posts ***
04-19-2017 09:58 PM
But I cant connect to device via Console Port. Hyperterminal can't find or detect device.
04-26-2017 08:02 AM
I am experiencing same problem here
04-19-2017 10:51 PM
via GUI!!!
did you try :
Login to WLC, click on Command > Reset to Factory Default
Regards
Dont forget to rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: