Wireless

I'm configuring SNMP on my Flexconnect Access Points. I configure the SMNP settings on the AP cli, and all is working 100%. As soon as I reboot the AP, the SNMP Config is gone (the rest of the config is still there) It seems it is being override by t...

Hi to everyone,I have problems to join an AP on the controller.  AP model is: AIR-AP1242G-E-K9 (They all are the same model, already 15APs on the controller)AP is reseted to factory default. DEBUG OUTPUT on AP*May 27 14:35:14.631: %LINK-3-UPDOWN: Int...

We have currently a setup with two 5508 WLAN Controllers (firmware 7.4.110.0) configured for AP SSO. Due to some network changes the IP address on the management interface and the redundancy-management interface must be changed to a new IP-range. As ...

Hello,I have problem authenticating Microsoft Surface 3 PC with WPA2 enterprise WLAN.All other PCs work fine. Any idea? ThanksJohnny 

Hello, need help for my AP 1142....all users using mobile always disconnecting please see logs 1Mar 1 02:57:50.139InformationInterface Dot11Radio0, Station 28cc.01c5.66ff Associated KEY_MGMT[NONE]2Mar 1 02:57:48.813InformationInterface Dot11Radio0, D...

Hello;I know there are many inputs into the DFS algorithm but I have 6 out of 11 APs operating on the same 2 * 20Mhz channels (36,40) , 4 are on (44,48) and a final on (64,60) - I have extended UNII-2 Channels enabled and have excluded 108 & 112, so ...

well I want to design a WLAN with 802.1x and EAP-TLS . We have a WLC 2500 , and bunch of Cisco AIR ,and Cisco ACS 5.4 as radius server.So we need a CA root. does WLC support built in CA ? what about ACS ?is it recommended to to configure WLC as CA se...

HelloI am using WLC 4400 and its max client capacity is 50 APs. Now I have 45 LWAPs working under WLC. For some reason, in random basis, users r getting disconnected to the APs and reconnects after few seconds. APs I am using is AIR-AP1131AG-A-K9 Ser...

               It keeps saying %CAPWAP-5-DHCP_RENEW: Could not discover WLC using DHCP IP. Renewing DHCP IP. then nothing happens. I want to turn device defaults and i dont know how.                I'm using Hyperterminal to access my device. 

hi!,    I'm kind a new on this "converged access" mode of configuration and I have a few questions...My scenario: 2 wlc (5508 software 7.6) working on HA on site A.... normal deploy of wireless on that site (nothing new)... Site B with 3650 switches ...

Hola porque el router de euskaltel EPC3825 no se pude actival el control pàrental y si es asi como.Un saludo

What's the best way to verify the SHA1 and MD5 Finger print of the certificate uploaded to Wireless controllers 5500 & WiSM?  

HelloI need a heads up we did a site survey carrying around an AP1602 to do radio measurements. We thus have made a map of where to position the APs so as to have minimal signal strength of -70 dBm anywhere wifi voice terminals will be used.OK so far...