cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8934
Views
5
Helpful
12
Replies

Change AP config for SSH/Telnet from AP Specific to Global Config

jcosgrove
Level 1
Level 1

I may be missing this but some how all the AP's on one of my controllers are set to "AP Specific" rather then "Global Config" for the telnet and ssh access for the AP's on the Advanced tab.

 

Is there a way to "bulk" change this config to "Global Config" so I can control this access under the Global Configuration section of the controller?

I have Prime and there does not seem to be an area in a Lightweight Configuration area to set this on the AP's.

 

The only way I see this is to go to each AP via the GUI or CLI and make the change.

 

Thanks for any advice.

 

1 Accepted Solution

Accepted Solutions