Change signal strength at access points

[gl_al]

How in wireless controller 5670 change signal strength at AP which work on a light version ?

[Sandeep Choudhary]

Check the power levels of AP :

these commands is for WLCs (2106/2504...) you check if these commands are available on 5760 or not!!!

show ap config 802.11a
show ap config 802.11b

You can set it to maximum (level 1) which will override the DTPC values.

see similer posts:https://supportforums.cisco.com/t5/getting-started-with-wireless/increase-signal-strength/td-p/2409492

https://supportforums.cisco.com/t5/getting-started-with-wireless/power-level-of-access-point/td-p/1579210

Regards

Dont forget to rate helpful posts

[gl_al]

show ap config 802.11a
show ap config 802.11b

wlc 5670 comannd not support (

#sh ap config ?
ethernet Shows Ethernet Vlan tagging Info for all Cisco APs
fnf Show Netflow input and output monitors for all Cisco APs
general Shows common information for all Cisco APs
global Shows global settings for all Cisco AP