Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All !!
Have two switch WS-C3850-24S and i want add to stack, but switch have different firmware. In one have WS-C3850-24S 03.06.02aE cat3k_caa-universalk9 INSTALL
ipbasek9 Permanent ipbasek9
and on the other
WS-C3850-24S...
Hi All !!
I have server ISE and use as radius server, add to ISE and configured on the switch 2960 802.1 x and MAB authentication, but not understand how to make it on the switch 3850. What is the difference(feature) between the configuration swit...
Hi All!
Tell me please, can i adjust the signal level on the AIR AP 2702? I use Lightweight firmware. Becouse when notebook connect to AP my connection speed no more than 72Mbit, mobile device connection speed 65 Mbit.
Hello!
I have two wifi controller 5760 and AP Lightweight Access Points. I configure one controller and works fine now.But I want configure wifi controllers support failover. If one primary controller is down, working secondary and all setting trans...
show ap config 802.11ashow ap config 802.11bwlc 5670 comannd not support (#sh ap config ? ethernet Shows Ethernet Vlan tagging Info for all Cisco APs fnf Show Netflow input and output monitors for all Cisco APs general Shows common inform...
