Check Cisco C-ANT9103 details on Cisco prime or WCL

[omer farukh]

I'm trying to get the details for the Cisco C-ANT9103 on Cisco Prime/WCL. Is there an option on Prime to get the details (serial number) of the antenna connected to the Cisco C9130AXE-E Access point, As it is in production and running, I have only the option to check it via Cisco Prime or WLC...

Please give advice

[balaji.bandi]

Not that i am aware you get antenna Serial number - general information you get - show ap inventory all (from WLC)

[Leo Laohoo · Accepted solution]

Remote into the AP and use the command "show controllers dot11Radio <0-3> antenna".

[omer farukh]

0A11-AP2>sh controllers dot11Radio 0 antenna
wifi0 Link encap:Ethernet HWaddr 88:9C:AD:01:AB:60
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:108330 errors:3955 dropped:77407 overruns:0 frame:0
TX packets:356133 errors:522 dropped:522 overruns:0 carrier:0
collisions:0 txqueuelen:2699
RX bytes:51089243 (48.7 MiB) TX bytes:397407252 (378.9 MiB)

Antenna: RX [ a b c d ]
TX [ a b c d ]
External
Antenna Gain: 1. 6dBi 2. 6dBi 3. 6dBi 4. 6dBi
DART connector capable:CAPABLE
DART connector status :PRESENT

SIA RPTNC: NOT_SUPPORTED
SIA DART : Present: 1, Gain: 6
SIA PID: C-ANT9103=
SIA Description: Marlin-3 8-port Directional

0A11-AP2>sh controllers dot11Radio 1 antenna
wifi1 Link encap:Ethernet HWaddr 88:9C:AD:01:AB:60
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:5552154 errors:34541 dropped:469 overruns:0 frame:0
TX packets:10162580 errors:635327 dropped:635327 overruns:0 carrier:0
collisions:0 txqueuelen:2699
RX bytes:3781812641 (3.5 GiB) TX bytes:2597931756 (2.4 GiB)

Antenna: RX [ a b c d e f g h ]
TX [ a b c d e f g h ]
External
Antenna Gain: 1. 6dBi 2. 6dBi 3. 6dBi 4. 6dBi 5. 6dBi 6. 6dBi 7. 6dBi 8. 6dBi
DART connector capable:CAPABLE
DART connector status :PRESENT

SIA RPTNC: NOT_SUPPORTED
SIA DART : Present: 1, Gain: 6
SIA PID: C-ANT9103=
SIA Description: Marlin-3 8-port Directional

...........................

I couldn't find any of the details (serial number).

[Leo Laohoo]

Me bad. 

I do not believe I know of any commands that will return the serial number of the antenna.