Cisco 1562D running 8.10.142 code cannot enable trunking on AP.

[willCannon]

I have 2 cisco 1562D Aps that i am configuring as a remote bridge with one AP being the RAP and ME controller and the other being a MAP. They are both running 8.10.142 code, i have Ethernet bridging enabled and when i got to edit the gigabit interface Ethernet 0 to change it from access to trunk it says that the AP has trunking disabled. Is there a way through the CLI or mobility express to enable this feature at the AP level? 

[marce1000]

 - Check if these info's can be helpful :

            https://www.cisco.com/c/en/us/td/docs/wireless/technology/mesh/8-0/design/guide/mesh80/Connecting_the_Cisco_1500_Series_Mesh_Access_Points_to_the_Network.html?bookSearch=true#ID6959

   https://www.cisco.com/c/en/us/td/docs/wireless/technology/mesh/8-0/design/guide/mesh80/Connecting_the_Cisco_1500_Series_Mesh_Access_Points_to_the_Network.html?bookSearch=true#ID7045

 M.

[willCannon · Accepted solution]

I actually ended up tracking it down. I had to go into the CLI for the controller and throwing this command in: 

config ap vlan-trunking enable ap-name

[Scott Fella]

Great job posting the solution!  Makes it easy for others in the future to quickly find answers.