Cisco 4404 WLC

[stheriault99]

I want to etherchannel my Cisco 4404 to my Catalyst 6513. I create the etherchannel on my 6513, but was wondering how I create my etherchannel on my Cisco 4404? The commands are not the same as my Catalyst 6513. Any guidance would be appreciated.

[Scott Fella]

You need to go to the General tab on your 4404 GUI and set LAG to enable. Also make sure you configure your etherchannel to channel-mode on and that etherchannel load balance is configured to scr-dst-ip.

[naks]

Here is the link to the config guide on cisco site that explains the procedure

http://www.cisco.com/en/US/docs/wireless/controller/5.0/configuration/guide/c5mint.html#wp1113877