Wireless

We just started testing WPA2 on our IOS APs & WLCs; no problems yet except for with the 1250. We have a 1250 running IOS 124-10b.JDA. Some users get authenticated and get a DHCP address no problems. A handful of users (no common thread yet in terms o...

Hello,We recently had a few clients being locked down with countermeasures by our WLC 4404 due to TKIP-MIC errors. After doing some reading on the benefits of AES over TKIP I switched our WLAN security settings to AES, and pushed a new wireless polic...

It's possible to configure Aironet 1300 Series to works as bridge and acces point in the same time ?What antenna do you recommand for point to multipoint configuration ?

Hi everybody,I got this trap massage on WLC.The client failed to communicate, it was still associated wiht WLC though.the trap massage log is blow"Decrypt errors occurred for client 00:40:96:ae:38:fe using unknown key on 802.11a interface of AP 00:16...

Involved hardware / software:2x Cisco 6509E in VSS-1440 configuration 6509E running software version 12.2(33)SXI2x WS-SVC-WISM-1-K9 WiSM module (1 per 6509) WiSM running software version 4.2.205.01x WCS version 4.2.128.0 This is according to Cisco th...

Is it possible to do both wired AND wireless Guest access on the same controller? The Design Guide I have read assumes you will only have 1 Guest lan per controller and thats the wired guest LAN. If thats the case why would you deploy a WLC for wired...

I'm using a AIR-BR1310-E-K9-R as ROOT and 5 NON ROOTS type (AIR-BR1310-E-K9).Im looking for a default config to setup a wireless PTMP link between the ROOT and the NON ROOTS. To make this wireless connection i'm using an AIR-ANT2506

Hi I have a 3750 Controller with 1510 access points. I have 1 access point that will not join. I think it was configured as a remote with a fixed IP address but I don't know what that address is, and I think that it is not the right subnet. I think I...

I have a small WLAN, that I am upgrading with a managed switch (Alcatel OA 4012). I have 4 1120B APs and many 1220B/1231G APs. They work with the power injector, but this switch supports POE. I don't find the "power negotiation" settings in the Web G...

How is this done? We bought a certificate file and have 2 4404 controllers. Where do I go to apply this and how do I apply this?Also will my single cert work for 2 controllers?

How can I tell AP's in one building to broadcast one SSID while AP's in another building broadcast a different one?We have WLC and WSC.

Hi Guys,Trying to get a Nokia E51 authenticated to a WLAN, and get the following :Invalid RSN Descriptor code (254) from mobile xx:xx:xx:xx:xx:xxThen it reties, and then retires, and the hits the limit of 3 and fails.Here is the debug info.Anyone see...