I am trying to configure the wireless part on the cisco 887w router.
I am unable to enter the service module. I tried searching for answers in this forum, every answer is related to configuring the service module part, not related to accessing the service module.
I am trying to configure the wireless network on the same LAN VLAN 200, so i gave the command ip unnumbered vlan 200 and started the service module.
// r1#service-module wlan-ap 0 session
Trying 10.10.1.20, 2002 ... Open
Connecting to AP console, enter Ctrl-^ followed by x,
then "disconnect" to return to router prompt //
After this the whole thing just hangs, I cant even disconnect using control shift 6 and x.
I also tried creating a separate vlan for the wireless interface and separate ip, but still cant access the service module.
Gives the same error.
Help needed.
status is as follows
Service Module is Cisco wlan-ap0
Service Module supports session via TTY line 2
Service Module is waiting for registration message
Service Module reset on error is disabled
Service Module heartbeat-reset is enabled
Service Module is in fail open
Service Module status is not available
