cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
778
Views
10
Helpful
4
Replies

cisco 9130AXE-E regulatory domain problem with 5G

shlomoi
Level 1
Level 1

Hi friends,

We recently purchased a 9800 controller and  20 AP model  9130AXE-E.
I set  the controller but the AP does not transmit a 5G frequency. When I check the AP status I see that the

regulatory domain is -E.

I set the country code to my country israel  -L. But I still have the same  problem

Is it possible to change the regulatory domain through the controller.

 

 

ap 9130.PNG

 

Thanks

 

shlomo itzhak

2 Accepted Solutions

Accepted Solutions

Radu96069
Level 1
Level 1

Hi,

 

Not 100% sure but I remember reading somewhere that the regulatory domain is "hard-coded" in the product.

You can change the county from the controller but only countries covered by -E domain.

Wireless LAN Compliance Lookup (cisco.com)

I think you need to change those AP with ones that are made for your regulatory domain( -I). Check with the partner.

View solution in original post

Rich R
VIP
VIP
4 Replies 4

Radu96069
Level 1
Level 1

Hi,

 

Not 100% sure but I remember reading somewhere that the regulatory domain is "hard-coded" in the product.

You can change the county from the controller but only countries covered by -E domain.

Wireless LAN Compliance Lookup (cisco.com)

I think you need to change those AP with ones that are made for your regulatory domain( -I). Check with the partner.

Hi
Thank you very much for your help

Shlomo itzhak

ammahend
VIP
VIP

For Israel regulatory domain is I not E, the AP might not work.

-hope this helps-

Rich R
VIP
VIP

Is it possible to change the regulatory domain through the controller?

NO

Review Cisco Networking for a $25 gift card