01-17-2024 09:49 AM
Hello All,
I am suing C9800-L-F-K9 with 17.9.3 image and trying to use both ports for C9136I Wap.
WAP is connected to C9300-24UX model with image 17.9.3
Issues
Switch is configure with LACP Config and LAG is enabled on AP join profile in WLC
I am seeing below error on switch
%ETC-5-L3DONTBNDL2: Tex/x/x suspended: LACP currently not enabled on the remote port.
your inputs will be helpful, pls help
01-17-2024 09:53 AM
Can i see the page you config LAG ?
Did you use lacp in wlc ? Or run mode ON?
MHM
01-17-2024 10:03 AM
we enabled LAG on AP Join Profile not globally . in WLC i do not see any option for Mode on
01-17-2024 10:05 AM
So the WLC not support lacp
You need to make port channel in switch use mode ON
MHM
01-17-2024 10:08 AM
>...in WLC i do not see any option for Mode on
- It's to be set on the switch , as in (e.g.) :
switch# configure terminal
switch(config)# interface fastethernet 0/1
switch(config-if)# channel-group 5 mode on
Change interface name and channel group number accordingly and verify settings with :
show ethernet channel summary
M.
01-17-2024 10:00 AM
- Set LACP mode on , for the AP intended LACP ports ,
M.
01-17-2024 10:11 AM
@marce1000 @MHM Cisco World thanks for reply , does this mean WiFi6E waps will only work on Mode on not active ?
01-17-2024 10:16 AM
I think Yes'
If you not see lacp option in general (and also check it in management tab) then Yes it support only ON mode.
MHM
01-17-2024 11:05 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide