08-16-2017 09:43 PM - edited 07-05-2021 07:33 AM
Hi Everyone
Cisco air-ap2802i-s-k9 model run u-boot mode on picture Why is it ?
how to configuration to lap mode. Please provide how to and command let me know for this issue
Thank for advance
U-Boot 2013.01-g7a7330d (Mar 24 2016 - 18:15:30) Marvell version: 2015_T2.0p10
Board: Barbados-2K
SoC: MV88F6920 Rev A1
running 2 CPUs
CPU: ARM Cortex A9 MPCore (Rev 1) LE
CPU 0
CPU @ 1800 [MHz]
L2 @ 900 [MHz]
TClock @ 250 [MHz]
DDR4 @ 900 [MHz]
DDR4 32 Bit Width,FastPath Memory Access, DLB Enabled, ECC Disabled
DRAM: 1 GiB
NAND: 256 MiB
SF: Detected N25Q32A with page size 64 KiB, total 4 MiB
*** Warning - bad CRC, using default environment
PCI-e 1 (IF 0 - bus 0) Root Complex Interface, Detected Link X1, GEN 2.0
PCI-e 2 (IF 1 - bus 1) Root Complex Interface, Detected Link X1, GEN 2.0
Map: Code: 0x3fede000:0x3ffadc28
BSS: 0x3ffef640
Stack: 0x3f9cdf20
Heap: 0x3f9ce000:0x3fede000
U-Boot Environment: 0x00100000:0x00110000 (SPI)
Board configuration:
| port | Interface | PHY address |
|--------|------------|--------------|
| egiga1 | SGMII | 0x01 |
| egiga2 | SGMII | 0x00 |
Net: , egiga1, egiga2 [PRIME]
Hit ESC key to stop autoboot: 0
Starting board initialization process. Proceed? [y/N]: n
Aborting board initialization...
u-boot>>
08-16-2017 11:27 PM
Check this:
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvc32339/?referring_site=bugquickviewredir
Regards
Dont forget to rate helpful posts
01-22-2018 03:31 AM
03-02-2018 05:50 AM
Hello Suppawat,
Cisco air-ap2802i-s-k9 run U-Boot
Work around for Cisco air-ap2802i-s-k9 model run u-boot mode would be to reboot your AP .
For configuration to lap mode refer configuration guide in the below link.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide