03-02-2015 05:44 AM - edited 07-05-2021 02:38 AM
Hi,
I have AIR-CAP3702E-D-K9 AP. I wanted to use it as standalone AP as I do not have any WLC as of now. Is it possible? Later, once I have the controller I want to use it through controller.
Please guide.
Thanks
Vishal
Solved! Go to Solution.
03-02-2015 07:58 AM
Hello, gorle_vishal.
You need to have a support contract or SmartNet on your Aironet AP, in order to download a standalone image software. Would you know if you have a support contract on that AP?
Let me know if you have additional concerns or e-mail (adawa@cisco.com) me directly. Kind regards.
03-03-2015 01:12 AM
Hello Vishal,
Yes you can convert vice versa refer the link : https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa
03-02-2015 07:58 AM
Hello, gorle_vishal.
You need to have a support contract or SmartNet on your Aironet AP, in order to download a standalone image software. Would you know if you have a support contract on that AP?
Let me know if you have additional concerns or e-mail (adawa@cisco.com) me directly. Kind regards.
03-02-2015 09:36 PM
Hello adawa,
Yes we have SMARTNET support contract. Then its possible right?
Also let me know if I can convert it back to controller based from standalone.
Regards..
03-03-2015 01:12 AM
Hello Vishal,
Yes you can convert vice versa refer the link : https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa
03-03-2015 11:16 PM
Thanks mohanak!!
03-03-2015 08:26 AM
Hi, gorle_vishal.
As per mohanak, that is correct. You can convert it vice versa. Since you are also considering to have a WLC, what features are you looking into so i can send you more information. Please email me at (bsiapco@cisco.com) to assist you further.
Thanks!
03-03-2015 11:15 PM
Hi bsiapco,
Thanks for commenting. As of now I just want to confirm whether conversion from controller base to standalone and vice-versa is possible.
I shall write you when I need more details on this.
Thanks!
07-06-2019 04:02 PM
This thread seems a bit old. I have tried to flash an autonomous IOS to a 3702e and the DOT11RADIO1 goes dead.
I tried on two 3702E's. Each time I do a tftp hold down button to pull the image. Each time the 5gig radio becomes unoperational and wont even respond to conf t commands.
I'm trying to upload JBB(1) to the unit.
Does anyone know if an external antenna CAP 3702 be turned autonomous?
I read in some threads that it can't be done and the 5gig shuts down (which is what happens to me) and the unit becomes just a site-survey unit.
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide