01-03-2011 07:08 AM - edited 07-03-2021 07:36 PM
hi
i have configured windows 2003 server with DNS ,Active directory users and dhcp server. and configured my cisco 1130g AP .
i have installed cisco access control server 4.0 because i use LEAP authentication protocol and for the ACS for network configuration i give aaa client ip addresss as AP interface ip and same shared secret for the AP and ACS,.
so when i log to wifi it ask username and password
problem is lap top cannot have a ip address my dhcp server not issue any ip address .
my hiper terminal massage is like this when i connect to wifi
help ...thank you...
01-03-2011 11:31 PM
Did you try an SSID in open mode to make sure that connectivity and dhcp pool was correctly configured before trying to integrate with acs ?
It seems that here your authentication is failing, what is ACS giving as authentication failure reason ?
Nicolas
01-04-2011 07:57 AM
thanks for the reply
yes in the open mode SSID without any configuration i can connect to the internet and dhcp server issue ip address for the laptop.
how will i get ACS authentication failure reasons..
thank you..
01-04-2011 08:01 AM
Reports and Activity=> Failed attempts-> Active
Regards,
Nicolas
01-04-2011 08:22 AM
yes there is a massage "EAP type not configuerd "
thank you...
01-04-2011 08:36 AM
hi
but i enable LEAP authentication in ACS and Access point ,,then why it is asking eap type..???????
thank you....
01-04-2011 11:34 PM
There must be a reason ...
Can you post the access point configuration ? As well as the ACS screenshot where you are allowing leap ?
Thanks,
Nicolas
01-05-2011 03:12 AM
01-05-2011 04:22 AM
01-05-2011 05:12 AM
A "show run" is faster to collect on the AP command line and tells more than screenshots.
But it seems like you both configured the AP to use the ACS as radius server and the AP to also act as a local radius server (which should be removed if it's acs you want to use).
Regards,
Nicolas
01-05-2011 05:30 AM
thnks for the reply
if i configure 2008 server in PEAP authenticatoion can aironet 1130g communicate with it..
thank you..
01-05-2011 05:36 AM
The AP doesn't care about the eap method you are doing. It is between the client and the ACS that peap happens. So yes you can go ahead.
That maybe makes me think that your client was not configured for leap but you thought you had leap since you activated that on the AP ?
Nicolas
01-06-2011 03:11 AM
thnks fo reply
and there is a another issue that when i connect to wifi it ask user name and password ,,but after i provide it wifi try to access and there is failure..
is there any issue with active directory?????
01-06-2011 05:36 AM
No. the question is how did you configure your client ...
01-06-2011 05:50 AM
what do you mean by that ???
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide