Cisco Aironet 1850 Series Mobility Express Cannot reach other Networks

[ChinedumIloanusi82608]

Hello there,

I am not very familiar with the solution, I am trying to integrate RADIUS with my AP and also Syslog on the AP but the network administrator says he does not see any traffic on the network firewall which leads me to believe the traffic is not leaving the controller. Is there some sort of host firewall preventing outbound traffic or how do i configure routing to another network. I also noticed i cannot ping the gateway IP

[Sandeep Choudhary · Accepted solution]

did you check your routing ?

paste the swicthport config where 1850 AP are connected!

Regards

Dont forget to rate helpful posts

[ChinedumIloanusi82608]

Hello,

Thanks for your response, do you mind rephrasing the answer.
I am not really a network person, filling in for someone who is unavoidably absent.

Commands i can use will be helpful too

[Sandeep Choudhary · Accepted solution]

can you paste the config of the Swich where AP is connected?

Also paste the config of the switch where you are doing the inter vlan routing(Layer 3 switch/router)

Regards

Dont forget to rate helpful posts