CISCO AIRONET 2700 NO ACCESS TO LOCAL RESOURCES
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-30-2016 02:40 PM - edited 07-05-2021 04:58 AM
Hello
I can not connect to the server access (for ip I can but I can not name) WIRELESS
I can connect to the server by utp (IP address and server name) WIRED
Ejecuto el siguiente comando en windows
\\x.x.x.x or \\servername
I have no domain
I do not have DNS
I have three vlans, one wired and two wireless
If I ping the server from the access point if I reach
It can be?
server ip:192.168.1.3
area_gerentes#ping 192.168.1.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms
area_gerentes#
flash:/ap3g2-k9w7-mx.153-3.JAB/ap3g2-k9w7-xx.153-3.JAB"
area_gerentes#sh run
Building configuration...
Current configuration : 3601 bytes
!
! Last configuration change at 05:42:24 UTC Mon Jun 7 1993 by Cisco
version 15.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname area_gerentes
!
!
logging rate-limit console 9
enable secret 5 $1$BMHN$Yn6JYb/CJZLbGHclSnPCP.
!
no aaa new-model
process cpu statistics limit entry-percentage 40 size 300
no ip source-route
no ip cef
!
!
!
!
dot11 syslog
!
dot11 ssid Aps
vlan 21
authentication open
authentication key-management wpa version 2
mbssid guest-mode
wpa-psk ascii 7 072E315F5C1E4E5242405B5D52
!
dot11 ssid Aps_agentes
vlan 22
authentication open
authentication key-management wpa version 2
mbssid guest-mode
wpa-psk ascii 7 03365E0D091D2C4D0D584D51
!
dot11 ssid Nativa
vlan 28
authentication open
authentication key-management wpa version 2
mbssid guest-mode
!
dot11 ssid ssid Aps_agentes
!
!
!
!
!
username CISCO password 7 00271A150754
username ADMINISTRATOR privilege 15 password 7 040F0F0B5E2F1D1B1D0B510342190B0A3A79747966
!
!
bridge irb
!
!
!
interface Dot11Radio0
no ip address
!
encryption vlan 21 mode ciphers aes-ccm
!
encryption vlan 22 mode ciphers aes-ccm
!
encryption vlan 28 mode ciphers aes-ccm
!
ssid Aps
!
ssid Aps_agentes
!
ssid Nativa
!
ssid ssid Aps_agentes
!
antenna gain 0
stbc
mbssid
station-role root
!
interface Dot11Radio0.21
encapsulation dot1Q 21
bridge-group 21
bridge-group 21 subscriber-loop-control
bridge-group 21 spanning-disabled
bridge-group 21 block-unknown-source
no bridge-group 21 source-learning
no bridge-group 21 unicast-flooding
!
interface Dot11Radio0.22
encapsulation dot1Q 22
bridge-group 22
bridge-group 22 subscriber-loop-control
bridge-group 22 spanning-disabled
bridge-group 22 block-unknown-source
no bridge-group 22 source-learning
no bridge-group 22 unicast-flooding
!
interface Dot11Radio0.28
encapsulation dot1Q 28 native
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Dot11Radio1
no ip address
shutdown
antenna gain 0
peakdetect
no dfs band block
channel dfs
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface GigabitEthernet0
no ip address
duplex auto
speed auto
!
interface GigabitEthernet0.21
encapsulation dot1Q 21
bridge-group 21
bridge-group 21 spanning-disabled
no bridge-group 21 source-learning
!
interface GigabitEthernet0.22
encapsulation dot1Q 22
bridge-group 22
bridge-group 22 spanning-disabled
no bridge-group 22 source-learning
!
interface GigabitEthernet0.28
encapsulation dot1Q 28 native
bridge-group 1
bridge-group 1 spanning-disabled
no bridge-group 1 source-learning
!
interface GigabitEthernet1
no ip address
duplex auto
speed auto
bridge-group 1
bridge-group 1 spanning-disabled
no bridge-group 1 source-learning
!
interface BVI1
mac-address 80e0.1dac.134c
ip address 192.168.2.199 255.255.255.240
ipv6 address dhcp
ipv6 address autoconfig
ipv6 enable
!
ip default-gateway 192.168.2.194
ip forward-protocol nd
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
ip route 0.0.0.0 0.0.0.0 192.168.2.194
!
!
bridge 1 route ip
!
!
!
line con 0
line vty 0 4
login local
length 0
transport input all
!
end
area_gerentes#
Regards.
- Labels:
-
Aironet Access Points
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-01-2016 02:11 PM
Where is the DHCP pool defined for those vlans, make sure it give correct DNS info to clients. This should be DNS releated for wireless clients
HTH
Rasika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-02-2016 08:01 AM
Hi
They are the same.
ip dhcp pool DATA
network 192.168.1.0 255.255.255.128
default-router 192.168.1.1
dns-server 8.8.8.8
!
ip dhcp pool DATA_WLAN
network 192.168.1.128 255.255.255.128
dns-server 8.8.8.8
default-router 192.168.1.129
!
ip dhcp pool DATA_WLAN_GUEST
network 192.168.2.0 255.255.255.128
default-router 192.168.2.1
dns-server 8.8.8.8
The problem persists.
Regards.
