Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Hi , Just wanted to Understand how to Achieve push notification on CMX. we have setup in place and below are the details. CMX 10.3 MSE Cisco Prime WLC 2504 and AP pls let us know what other components are required to Achieve push notifications Use ca...
Just came across this tool but having a few issues. I'm a newbie to all this but I've followed the instructions but I'm receiving a "Controller information not found in selected file. Please load the output of shrun-config, with paging disable for be...
Hi Guys , I'm bit new to Cisco Wireless I have few concerns to clarify regarding the WLC Mobility and HA what is the difference between both if you setup mobility between two controllers by giving MAC address of the controllers does it make HA Do ...
I have a Cisco 1852e on my network. It is broadcasting and I can connect and access the internet. I can also ping the device and can SSH into it but I cannot access it through the web interface. How can I turn on http on this device? The CLI command ...
I was looking for the best (or only) way to find/visaulize the nearby AP(s) to one other. Prime can do a report or visualize it per AP but that only shows the switch neighbor. Or it the command 'show ap auto-rf [802.11a/802.11b] <Cisco AP>' the c...
For example if I set a per-SSID bandwidth limit to 5 Mbps, does it do any good to also set a client limit?What are the best practices here?I have a business cable ISP WAN connection of 300/30
Hello ,I'm following this guide http://www.cisco.com/en/US/docs/wireless/technology/wips/deployment/guide/WiPS_deployment_guide.htmlbut I can not see Enhanced WIPS Enginefeature?I have this licencsewIPS Local Mode APs ThanksEmiliano
How to block the users to access other SSIDs configured on the same controller. Since we will only web authentication on L3 Security. And How can we make the configuration to open a default web-authentication page while connecting to SSID.
Need to split a 5508 HA pair to change the management IP address and vlan where they reside. What happens to the management IP on the secondary as it is typically shared with the primary when the HA pair is split? Does the unit resume on the IP whi...
Hi, Since we upgraded our WLC's to Code 8.3.132.0 we are facing issues with our Cisco WAP321. They are configured in Workgroup Bridge Mode and I'm still able to connect to the Web GUI. But the Device connected to the Ethernet Port of the WAP321 is ...
I'm trying to improve speeds on my wireless network. Right now I'm getting the following: (these are the best results in a 5 test trial) Download: 101.58 Mbps Upload: 91.27 Mbps After launching a wifi spectrum analyzer type app on my phone, it ...
Can we use R-type antennas on a N-connector AP - and vice versa? Using the appropriate R-N adapters to physically connect the two, is this acceptable? If acceptable, what is the impact on signal strength and coverage?
How do I configure WLC to be able to connect 200 clients in one big room? Need to put in more Ap nodes in that room. Today I have one and 3 beside the room. All clients can not connect when the APs get overloaded at big meetings. Can you please expl...
Dears, i have 3no's of AP 1852 with an image as per below these all in one subnet but the problem is nobody is accepting the controller to another, how i can do that.also when the username and password what i am using for the cli it doesn't accept...
