How to reset AIR-AP1242AG-A-K9 to defaults and keep the static IP

[Aaron Alvarado]

All,

 whats the command to completely reset a cisco AIR-AP1242AG-A-K9 device but ensure I keep the static IP. these are remote devices and i need to reset them but keep the IP.

Any help will be appreciated 

[Sandeep Choudhary · Accepted solution]

Hi,

If you want to reset the access point to its default settings and a static IP address, use the write erase or erase /all nvram command.

If you want to erase everything including the static IP address, in addition to the above commands, use the erase and erase boot static-ipaddr static-ipmask command.

Regards

Don't forget to rate helpful posts

[Aaron Alvarado]

Sandeep Thanks..