Hi
if anyone can helpo it would be great.
I I using a cisco 350 within our building for laptops users.
We are using no servers for authentication.
I want to only allow our mac addresses to authenticate with the access point.
I also want to encrypt our data using WEP.
The problem I am haviong is that I have configured the mac addresses in the filtered section and applied it.So it has the list,but when i try using another card with a mac address that is not valid and in the list, I can connect with no probs.This means that my mac authentication is not working properly.
I then also configured a WEP key with 40 bit encryption and full encryption.
I configured 1 WEP key and the authentication type is set as open.
This is all I have done and it still does not seem to work.When I remove all configuration it works fine and i can connect but the data is not secure from outside sources so i neewd to get it working with encryption.
Can anyone give some advice or guidance.
