Wireless

Hi,Does anyone have any useful links about how to configure ACS server to use windows UN/PW for wireless client logins via 802.1x & Eap-fast?I can't seem to find a defined example for the ACS to Window DB install?Can anyone help?TaJames

Is there a certain procedure for adding another WCS server? other than builing another box and importing (restore) the data from the other box?

i am tryin to clean up the syslog.i am still getting alot (~200) of "max retires" errors.i looked up the message, and from what i can tell, it seems that when a client leaves "the bubble" the AP will continue to try connect to the client.i have it se...

I was wondering if someone could give me a better explanation of what the below commands do. The AP help for the command doesn't really help me a lot. Besides the textbook definition, when would you use them and when not to, what they're used for, re...

Hi,I am trying to get a 1200 setup as a repeater and have run into a problem, any help would be apprecaited.I have 3 vlans setup for wireless on site. One for radios/infrastructure, one for valid users with regular logins, and one for guests that jus...

Greetings all - perhaps this is posted or on the site howveer I did not see it anywhere. I have several 1231 Access Points that have an IOS on it but I would like to upgrade the IOS to the newer version. Can anyone provide a link or procedure on how ...

A customer wants Wireless access in a small area which is 250 yds outside their door, across a parking lot. My question, would signal from a 1200 WAP, with mast mounted antennas, reach this area or should I setup a bridge?

My 1231G Cisco on 12.3(7)JA2 is giving me the Critical error message: "Interface Dot11Radio0, failed - Driver transmit queue stuck," I have never seen this before. What does it mean, and can it be resolved? Thanks!

Does this message necessarily mean that the flash memory is damaged?AP#sh flash:Directory of flash:/%Error opening flash:/ (Invalid argument)No space information availableThanks.

I know that the power on 1310 is 20 mw for both cck and ofdm. On last bridge I saw (ios 12.3.7), I found out that these values changed: 50 mw for cck and 30 mw for ofdm. I tried to upgrade an old bridge to the new ios but the values didn't change.Wha...

HiI need to purchase a wireless access point and it will only be used to transmit data and nothing more. I have restricted my choice between a Linksys WAP54GP and Cisco Aironet 1100 but can't make up my mind on which one to buy. What does the Cisco b...

I am looking at connecting to a wireless ISP that has a tower just below my house, the signal strength is high enough that I can connect with a standard wireless card without having to use an external antenna. I would like to install a wireless route...

I know this AP ships with a full IOS but here is my design question. In another setup, I have used a similar AP as the default AP on the wifi network, but have used a PIX as the default gateway.On this network, I don't have a PIX or another router to...

I have implemented WLAN in a four floor building as per the following e.g.:-vlan 2 - 1st/3rd floor subnet 2.x.x.2 /24 - SSID Corporatevlan 3 - 2nd/4th floor subnet 3.x.x.3 /24 - SSID Corporatevlan 4 - all floors guest access subnet 4.x.x.4 /24 - SSID...