04-14-2010 08:32 AM - edited 07-03-2021 06:43 PM
Hello,
We have 2 Cisco Aironet Power Injector LR2's (AIR-PWRINJ-BLR2=) and I can't console to either using Cisco sky blue consoel cable.
I am using putty and my setting are:
Speed = 9600
Data Bits = 8
Stop Bits = 1
parity = none
Flow control = none
04-14-2010 03:37 PM
I don't believe you can console into a power injector. Why, if I should ask, are you doing this?
04-14-2010 11:04 PM
I was curious that's all. I have a 1301G to connect to it, is it used to configure that?
Thanks
04-15-2010 03:46 PM
Oh no.
The power injector has only two options: On or Off.
04-15-2010 10:43 PM
How do I configure the 1301 that connects to it via coaxial and why does the LR2 have a console port in the first place?
04-15-2010 11:05 PM
Under Network Management
The power injector does not require configuration or management.
Cisco Aironet 1300 Series Access Point/Bridge Power Injector
http://www.cisco.com/en/US/products/ps5861/products_data_sheet09186a008022551d.html
04-16-2010 04:31 AM
Go to the website posted below. Choose from either Configuration Examples & TechNotes or Configuration Guides.
http://www.cisco.com/en/US/customer/products/ps5861/tsd_products_support_configure.html
Hope this helps and please don't forget to rate our posts. Thanks.
12-17-2011 10:39 PM
I spend the same, the AP 1310 is OK, but the power led led off injector LR2. Consoledoes not work
12-17-2011 10:56 PM
but the power led led off injector LR2
Faulty cable to the WAP.
12-18-2011 09:15 AM
Console Cable is ok, but led off power injector. AP LED is ok
12-18-2011 01:35 PM
Console Cable is ok
I'm not talking about the console cable. The ethernet cable from the injector to the WAP could be faulty.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide