Wireless

Hican any body guide how to configure WLC 5500 and 16 access point using Cisco Aironet1140 Series Access Pointhow to configure

When installing 1250 AP on standard 802.3af PoE, according to the following: http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps6973/ps8382/product_data_sheet0900aecd806b7c5c.html  : operation will be limited to a single transmitter per rad...

We have just installed some new 8510 controllers and are doing some testing.We are unable to access the GUI if connected to AP's that are on the controller, but can from AP's that are on other controllers.  We do have manage via wireless enabled.  Is...

  Hi all I have implement VM-WLC with 30 AP License , we got user around 330 device to accosiated. I found that CPU reach about 72-80 % that make WLC hang. So,  i found some message below i don't sure that what is the meaing. Please give me the idea....

Dear all,anyone know that any software for wireless, which able to detect all type of wifi clients? in fact, i do have 4-5 autonomous ap, but i dont have any WLSE or WLC, as we only have not more than 100 usersEach user when connecting wifi, they mig...

Currently we are deploying a guest access solution for internet only services, using ISE MSE NCS and WLS's.What are the benefits of using Cisco solution over Windows 7 with direct access and VDi technology such as Moca5.

Hi everyone,I want to confirm if the access point (AIR-AP1141N-E-K9) can work with the Wireless LAN Controller(AIR-CT5508-25-k9)thankssam

Hello! Is this a problem from Apple or Cisco side?we have a cisco WLC 5508 on which few SSIDs are configured, and two kinds of APs: AIR-LAP1142N-E-K9 and converted AIR-AP1141N-E-K9.When in WLAN settings we leave WPA2 policy and AES encryption, iPads2...

I read in a forum that the IEEE standard version of MFP - 802.11w (called Protected Management Frames - PMF) - will be supported in WLC release 7.4 (expected in early Q1 2013).Is official maintenance release 7.4 for WLCs out yet? If not, when is it e...

I have a problem with a single IP address inside a network, composed by a layer-3 switch, a WLC 5500, and nine 1261 access points. The client uses static IP asignment inside its network, when the IP is configured on a PC connected by cable there isn´...

                   After a powerloss and reboot the unit will not start NCS. The running configuration file apears to be intact. Any suggestions would be apreciated. Currently generation failure logs.Thanks in advanceJohn D.

with Cisco Expert Nicolas DarchisWelcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about how to trobuleshoot, configure and deploy any Cisco Wireless LAN controller with Cisco subjec...

Hi all,I have spent a bit of time looking and am unable to find an answer to some questions, was wondering if you could help.Simple scenario: When an AP goes down, the WLC will send a trap to a trap receiver (Prime Infrastructure)My questions are:1) ...