Hello,
I have several Cisco APs 1141 in a Wireless Lan Controller 5508 with the 7.2 version.
The APs are registered correctly in the WLC, but when I want to change the AP Mode to "Bridge", the WLC shows an error message as this: "This mode not is supported in this model device AP"
Although the 1140 series APs support the bridge mode, I don´t understand why in the WLC I can´t configure the AP in that mode. I have read several documents of Cisco support and I haven't found nothing about this issue. And all of them write that APs 1140 support the Bridge mode.
Is there any problem with the WLC version? Is there any limitation with this AP model in mode centralized?
Thanks.