cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
346
Views
0
Helpful
6
Replies
Highlighted
Beginner

Cisco AP 1242 shows limited connectivity for users.

Hello,

we are using AIR-AP1242AG-A-K9 but from past few days it is showing limited connectivity to users and sometimes users are not able to connect.

what can be exact solution for this?

6 REPLIES 6
Highlighted
Enthusiast

Hello,

Try resetting to factory defaults and check if that helps.

You can reset the AP to factory defaults either from the controller or manually.

To clear the controller's configuration, choose Commands > Reset to Factory Default > Reset on the controller GUI, or enter the clear config command on the controller CLI. To clear the access point's configuration, enter the clear ap config Cisco_AP command on the controller CLI.

Manually Resetting the Access Point to Defaults

You can manually reset your access point to default settings using this EXEC mode CLI command:

Note This command requires the controller configured Enable password to enter the CLI EXEC mode.

 

clear lwapp private-config 

Hope that helps.

Highlighted

Hello Moin,

Thank you for the reply.

but factory reset and config erase also didn't help. Any alternative solution you can suggest on this?

Highlighted

Which IOS version running on your AP ? If there is any latest image for this AP model you can try upgrading the image & see.

HTH

Rasika

**** Pls rate all useful responses ****

Highlighted

Hi,

Just did that and kept under monitring.Will update once i get any upadte. Thanks.

Highlighted

Hope that will work.

If so you can mention the code you upgraded for others benefit & mark this thread as answered.

HTH

Rasika

 

Highlighted
Enthusiast

Hi,
Upgarde the IOS of your AP to the latest code and then check.

 

Content for Community-Ad